Lt 2012 Takes up 66% Less Floor Space than the Standard 12” Bulk Lectrotreats. The LT 2012, with it’s 12” tunnel size, is a direct replacement for the most popular LectroTreat of all time.
The LT 2012 takes up to 66% less floor space than the standard 12″ bulk LectroTreat. Even with its smaller foot print, the LT 2012 can achieve higher line speeds than the standard LectroTreats. The LectroTreat operates on a HV capacitor system creating an oxidized cold plasma inside the plasma tunnel at atmospheric pressure. All parts pass through the tunnel on a continuous conveyor system. The LT 2012 reaches a higher level of energy by supplying what is referred to as a directional plasma in air. This directional plasma allows any part to be completely treated.
LT 2012 Features & Benefits
Wet Surface Treatment Levels
Wet Surface Treatment Levels >70 dynes/cm2 over the entire outside of three dimensional plastic parts. Allows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes
No Heat
Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings
Versatility
No set-up required for
different shapes resulting in
labor and production savings
Open Atmosphere Plasma
Continual process, no vacuum
required, higher production rates
Safe Technology
Lower insurance premiums,
no open flames
Efficient Operation
Low cost
power construction
Low Frequency 50-60HZ
No interference with Electronic/PLC/Computers controls
PLC Controls
Reliable and repeatable production rates, allows interface with entire production line
Cold Plasma
360 degree uniform surface
treatment guaranteed
LT 2012 Specifications
Input Voltage |
Standard 240 volt, 3 phase Any voltage can be accommodated |
Frequency |
50-60HZ |
Total Electrical Load |
5 KVA on standard units |
Certification |
UL, CSA or CE components |
Equipment Dimensions |
46″ wide x 78″ long x 75″ height |
Conveyor Heights |
43.5″ above the floor |
Complete Systems |
Comes completely assembled. Ready to use, No set-up! |
Custom Design |
Available upon request |
Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.