Space-saving Surface Treater for 3D Parts — Oriented & Non-oriented

The LT 2000 is Lectro Engineering’s features the four plus decades of plastic surface treating equipment experience. It is smaller than and just as powerful as a standard LectroTreat with the same tunnel dimensions. It can be used in bulk or in-line applications. The unit has all the benefits of our standard open air plasma discharge system at a fraction of the cost.

Download Product Sheet
Watch the LT 2000 in Action
Compare the LT 2000 with 3D Corona
LT 2000

LT 2000 Features & Benefits

Surface Treatment Levels
Surface Treatment Levels

Surface Treatment Levels >70 dynes/cm over the entire outside of three dimensional plastic parts. Allows the decoration/ adhesion on plastic parts without the use of costly primers or chemical wipes.

No Heat

Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings.


No set-up required for different shapes resulting in labor and production savings

Continual Process
Open Atmosphere Plasma

Continual process, no vacuum
required, higher production rates

Safe Equipment

Lower insurance premiums,
no open flames

Efficient Operation

Low cost power

Low Frequency
Low Frequency 50-60HZ

No interference with Electronic/PLC/Computers controls

PLC Controls
PLC Controls

Reliable and repeatable production rates, allows interface with entire production line

Cold Plasma

360 degree uniform surface
treatment guaranteed

LT 2000 Specifications

Input Voltage

Standard 240 volt, 3 phase Any voltage can be accommodated



Total Electrical Load

5 KVA on standard units


UL, CSA or CE components

Equipment Dimensions

38″ wide x 72″ long x 60″ height
12″ conveyor extension each end

Conveyor Heights

37″ above the floor

Complete Systems

Standard unit includes surface treating, conveyor and exhaust systems.

Custom Design

Available upon request

Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.