LT 2000
The LT 2000 is Lectro Engineering's latest addition to four plus decades of plastic surface treating equipment. It is smaller than and just as powerful as a standard Lectro-Treat with the same tunnel dimensions. It can be used in bulk or in-line applications. The unit has all the benefits of our standard open air plasma discharge system at a fraction of the cost.
For more information, view PDF.
PDF Comparing the LT 2000 with 3D Corona
Features |
Benefits |
| Surface Treatment Levels >70 dynes/cm over the entire outside of three dimensional plastic parts | Allows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes |
| Open Atmosphere Plasma |
Continual process, no vacuum required, higher production rates. |
| Versatility | No set-up required for different shapes resulting in labor and production savings. |
| No Heat | Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings. |
| Safe Equipment | Lower insurance premiums, no open flames |
| Efficient Operation | Low cost power construction |
| Low Frequency 50-60HZ | No interference with Electronic/PLC/Computers controls. |
| PLC Controls | Reliable and repeatable production rates, allows interface with entire production line. |
| Cold Plasma | 360 degree uniform surface treatment guaranteed. |
Specifications |
|
| Input Voltage | Standard 240 volt, 3 phase Any voltage can be accommodated |
| Frequency | 50-60HZ |
| Total Electrical Load | 5 KVA on standard units |
| Certification | UL, CSA or CE components |
| Equipment Dimensions | 38" wide x 72" long x 60" height 12" conveyor extension each end |
| Conveyor Heights | 37" above the floor |
| Complete Systems | Standard unit includes surface treating, conveyor and exhaust systems. |
| Custom Design | Available upon request |
