In-Line Lectro-Treat

For more information, please view the PDF.

For adhesion solutions on 3-dimensional oriented plastic parts, Lectro Engineering offers the In-Line Lectro-Treat surface treating system. The In-Line Lectro-Treat is built for a specific part size, line speed, and application. Your parts can be placed directly on a conveyor belt or be placed on an over head hanging conveyor to consistently surface treat the entire outside of the part. The In-Line Lectro-Treat lends itself to assembling, painting, gluing, or any automated line were orientation is required.

 

Features

Benefits
Surface Treatment Levels >70 dynes/cm over the entire outside of three dimensional plastic parts Allows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes
Open Atmosphere Plasma

Continual process, no vacuum required, higher production rates.
Versatility No set-up required for different shapes resulting in labor and production savings.
No Heat Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings.
Safe Equipment Lower insurance premiums, no open flames
Efficient Operation Low cost power construction
Low Frequency 50-60HZ No interference with Electronic/PLC/Computers controls.
Low Maintenance Only periodic cleaning necessary.
PLC Controls Reliable and repeatable production rates, allows interface with entire production line.
Cold Plasma 360 degree uniform surface treatment guaranteed.

 

Specifications
Input Voltage Standard 240 volt, 3 phase Any voltage can be accommodated
Frequency 50-60HZ
Total Electrical Load Not to exceed 8 KVA on standard units
Certification UL, CSA or CE components
Conveyor Heights Standard 43.5" above floor
Other heights are available
Complete Systems Standard unit includes surface treating, conveyor and exhaust systems.
Custom Design Available upon request