Bulk Lectro-Treat

For more information, view the PDF.

When orientation of your parts is not required, the Bulk Lectro-Treat surface treating system is the solution. The parts can be either bulk feed or randomly placed onto the treating conveyor. With the Bulk Lectro-Treat there is no lost time for any set up changes for different sizes, or shapes of parts. As long as the part fits within the treating tunnel, the entire outside surface of the part is treated evenly insuring adhesion.

 

Features

Benefits
Surface Treatment Levels >70 dynes/cm over the entire outside of three dimensional plastic parts Allows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes
Open Atmosphere Plasma

Continual process, no vacuum required, higher production rates.
Versatility No set-up required for different shapes resulting in labor and production savings.
No Heat Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings.
Safe Equipment Lower insurance premiums, no open flames
Efficient Operation Low cost power construction
Low Frequency 50-60HZ No interference with Electronic/PLC/Computers controls.
Low Maintenance Only periodic cleaning necessary.
PLC Controls Reliable and repeatable production rates, allows interface with entire production line.
Cold Plasma 360 degree uniform surface treatment guaranteed.

 

Specifications
Input Voltage Standard 240 volt, 3 phase Any voltage can be accommodated
Frequency 50-60HZ
Total Electrical Load Not to exceed 8 KVA on standard units
Certification UL, CSA or CE components
Equipment Dimensions Standard 43.5" above floor
Other heights are available
Conveyor Heights 37" above the floor
Complete Systems Standard unit includes surface treating, conveyor and exhaust systems.
Custom Design Available upon request